Driver Change - VDO KTCO 1318-24 Manual Del Usaurio

– Set the time group control knobs
(1 and 2):
Knob 1: driver
Knob 2: co-driver
How to remove the tachograph charts
The tachograph charts must be removed
at the end of the working day, at the time
of driver change or after 24 hours at the
latest (for reference numbers refer to
figure IX).
– Open the tachograph.
– Remove the driver's chart (8).
– Lift the separation plate (4) in the
direction of the arrow (3).
– Remove the co-driver's chart (5).
– Lower the separation plate (4) in
the direction of the arrow (7).
– Close the tachograph.
– Complete the entries in the centre
field for driver and co-driver
separately.
Note regarding one driver operation
(1 + 2-driver tachograph without co-driver)
In micro-processor version (see type
plate "EMV μP") no blank chart is to be
inserted below the separation plate!
– Therefore, in case of one driver
operation, set the time-group con-
trol knob 2 to position "
otherwise function check LEC lights
up.
© Continental Automotive GmbH
4.3 Driver change (Figure X, 3)
a) Driving by turns: co-driver becomes
driver:
– Exchange tachograph chart
– The new driver now operates
b) Driver or co-driver leave the vehicle:
– The one leaving the vehicle
– The new driver inserts his chart
Or
– The new co-driver places his chart
c) Driver and co-driver leave the
vehicle:
– Each of them takes his chart
– The new crew members place
Please note:
", as
When removing the diagram chart(s)
from the tachograph or when parking the
vehicle the time group switch is to be set
on position "
positions in tachograph.
the time group control knob 1,
the co-driver operates the time
group control knob 2.
takes his chart with him.
(with the manual entries requi
red) above the separation plate.
(with the manual entries required)
under the separation plate. If
there is no new co-driver, the
time group control knob 2 must
be switched to break time "
with him.
their tachograph charts in the
appropriate positions in the
tachograph.
".
".
23