Paper Dust Bag (For The User); Fiber Dust Bag (For The User); Belt Tension (For The User); Bearings (For The User) - Bona Capricorn Manual De Funcionamiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 62
Routine Maintenance (Cont.)

Paper dust bag (for the user)

Disposable paper dust bags,
available in packs of 3. The
limit for use is 1/3 of the total
capacity.

Belt tension (for the user)

Check belt tension regularly. For
adjustment procedures see page
10 of this manual.
If the belt is excessively worn it
must be replaced.

Bearings (for the user)

Check bearings regularly for wear or damage according to the following timescales:
WHEELS
FAN SHAFT
SANDING DRUM
MOTOR SHAFT

Drum pulley and motor pulley (for the user)

Regularly check that the groove (A) of the pulley has not sunk,
otherwise the belt (B) will operate on the bottom (C) of the pulley
itself.
Pulleys with sunken grooves cause the belts to slip and the correct power will not be transferred to the
drum/suction pipe. This situation can easily occur if the machine loses power during operation. They
should therefore be replaced.

Spare Parts

Always use Bona/Künzle & Tasin spare parts.
Failure to use Bona/Künzle & Tasin spare parts, or repairs/adjustments carried out by unauthorized personnel, will
invalidate the guarantee and any resulting liability.
The machine must only be repaired by qualified personnel.
This electric equipment is compliant with the relevant safety legislation. Repairs must be carried out by qualified personnel
using Bona/Künzle & Tasin spare parts, otherwise the user may suffer serious injury.
18

Fiber dust bag (for the user)

Remove the fiber dust bag, close it and shake
it well to remove sawdust.
Turn the bag inside out and wash it in the
washer-machine in cold water to prevent
blockage of the pores and a decrease in dust
collection ability.
after the first
2.500 hours
after the first
2.500 hours
after the first
5.000 hours
after the first
5.000 hours
Excessive belt tension may cause the premature failure of the ball
bearings.
The drum belt must have a 10.5 mm stretch with a center load of
30 N ± 3 N.
Bona Capricorn Manual

Publicidad

Tabla de contenido
loading

Tabla de contenido