BriskHeat JHS-GET Manual De Instrucciones página 3

INSTALLATION
1. Overlap approximately 12" (30cm) of
heating cable to allow for wire connections
and mishaps.
12 in
(30 cm)
2. Install the Pressure Seal End then the
Grommet onto each cable.
3. Carefully, lightly score/cut the outer jacket.
CAUTION : Do not cut the braiding.
4. Slightly bend the cable where you made
the cut and carefully strip the other jacket
from the heating cable.
®
© BriskHeat Corporation. All rights reserved.
JHS-GET
Low-Profile Inline Splice Connection Kit
5. Push the braiding back to create a bump.
6. At the bump, use a screwdriver to make a
little hole in the braiding.
7. Bend the cable and work it through the
braiding.
8. Make a pig-tail with the braiding at the
center of the cable to form a braided wire.
9. Lightly score inner jacket.
CAUTION : Do not cut the bus wire.
5
10. Bend cable and strip inner jacket from the
heating cable.
11. Nick the core material.
12. Pull back bus wires then, carefully strip
bus wires.
13. Carefully cut the center area (core)
between the two bus wires.
14. Bend and carefully remove the core
material.
®
© BriskHeat Corporation. All rights reserved.
JHS-GET
Low-Profile Inline Splice Connection Kit
15. Strip the two bus wires.
For CSA Class II and III: Skip to step 19.
16. Wrap the pigtail braid and the inner jacket
at least 3 loops using fiberglass tape.
17. Separate from the cable and loop a
minimum of two times around the braid.
18. Install the grommet to the edge of the loop
tape.
CAUTION: Do not install grommet over
the tape.
19. Insert heating cables into the main box.
20. Install grommets into cavities and seat
them into the pressure seal ends.
21. Install pressure seal ends onto the main
box by tightening screws.
6