Fuse Replacement - TechGrow Clima Micro Plus Manual

The next screen appears:
Temp 26c
Reset
The values have been reset. The main screen appears
after a few seconds.
Secondly, by completing the following steps:
1. The main screen is displayed:
Temp 26c
Set 27c
2. Put a precision screwdriver (or paper clip) in the
small round hole on the back of the Clima Micro
Plus Min/Max Fan Speed and press just one time.
The next screen appears:
Temp 26c
Reset
The values have been reset. The main screen
appears after a few seconds.

5. Fuse replacement

If a short circuit occurs due to fan overload, the fuse will
blow. Even if the Clima Micro Plus Min/Max Fan Speed
does not operate at all, in the worst case, this could
indicate a blown fuse. To replace the fuse you have to
open the Clima Micro Plus Min/Max Fan Speed.
Complete the following steps:
1. Remove the plug from the socket.
2. Open the housing by unscrewing the 4 screws on
the back of the Clima Micro Plus Min/Max Fan
Speed.
3. Locate the fuse and remove it.
4. Insert a new 5 amp fuse.
5. Screw the 4 screws to close the housing.
Your Clima Micro Plus Min/Max Fan Speed is ready for
use again.
____________________________________________________________________________________________________________________________
TechGrow | Innovative Growing Solutions 12