Safety - Craftsman 124.34986 Instrucciones De Uso

ELECTRICAL REQUIREMENTS
POWER SUPPLY AND MOTOR SPECIFICATIONS
WARNING: To avoid electrical hazards, fire hazards, or damage to the
tool, use proper circuit protection. Use a separate electrical circuit for
your tools. To avoid shock or fire, if power cord is worn or cut, or dam-
aged in any way, have it replaced immediately.
GROUNDING INSTRUCTIONS
WARNING: This tool must be grounded while in use to protect the op-
erator from electrical shock.
IN THE EVENT OF A MALFUNCTION OR BREAKDOWN, grounding
provides a path of least resistance for electric current and reduces the
risk of electric shock. This tool is equipped with an electric power cord
that contains an equipment-grounding conductor wire and a 3-prong
plug with a grounding pin. The plug MUST be plugged into a matching
receptacle that is properly installed and grounded in accordance with
ALL local codes and ordinances.
DO NOT MODIFY THE PLUG PROVIDED. If it will not fit the recep-
tacle, have the proper receptacle installed by a qualified electrician.
IMPROPER CONNECTION of the power cord can result in risk of elec-
tric shock. If repair or replacement of the electric cord or plug is neces-
sary, DO NOT plug it into an electrical outlet.
CHECK with a qualified electrician or service person if you do not com-
pletely understand the grounding instructions, or if you are not sure the
tool is properly grounded.
WARNING: Improper connection of equipment grounding conductor
can result in the risk of electrical shock. Equipment should be grounded
while in use to protect operator from electrical shock.
- Check with a qualified electrician if you do not understand grounding
instructions or if you are in doubt as to whether the tool is properly
grounded.
- This tool is equipped with an approved cord and a 3-prong grounding
type plug for your protection against shock hazards.
- Grounding plug should be plugged directly into a properly installed
and grounded 3-prong grounding-type receptacle, as shown.
- Do not remove or alter grounding pin in any manner. In the event
of a malfunction or breakdown, grounding provides a path of least
resistance for electrical shock.
WARNING: This Drill Press is for indoor use only. Do not expose to rain
or use in damp locations.
GUIDELINES FOR EXTENSION CORDS
USE PROPER EXTENSION CORD. Make sure your extension cord is
in good condition. When using an extension cord, be sure to use one
heavy enough to carry the current your product will draw. An undersized
cord will cause a drop in line voltage, resulting in loss of power and
cause overheating.
Be sure your extension cord is properly wired and in good condition. Al-
ways replace a damaged extension cord or have it repaired by a quali-
fied person before using it. Protect your extension cords from sharp
objects, excessive heat and damp or wet areas.

SAFETY

5