Before Calling Service - Samsung RSG307 Serie Manual Del Usuario

1. Connect the household water line to the
assembled compression fitting.
- If you are using copper tubing, slip the
compression nut (B) (not included) and ferrule
(not included) on copper tubing (not included) as
shown.
- If you are using plastic tubing (B), insert the
molded end(Bulb) of the plastic tubing (B) into the
compression fitting.
Do not use without the molded end(Bulb) of
the plastic tubing (B).
cAuTION
2. Tighten the compression nut (B) onto the
compression fitting. Do not over-tighten the
compression nut (B).
3. Turn water on and check for any leakage.
Only connect the water line to a drinkable
water source.
If you have to repair or disassemble the water
line, cut off 1/4" of the plastic tubing to make
sure you get a snug, leak-free connection.
BEFORE uSING IcEMAkER
Remove
- Hold the handle as shown in
Figure1.
- Slightly pull up the bottom part.
- Take out the ice bucket slowly.
Install
-
Assemble the icemaker in the
reverse order of disassembly.
-
Push the bucket in firmly until
you hear a clicking sound.
- If the bucket does not fit into its
place, turn the gear handle on its
back by 90 degrees and reinstall
it again as shown in Figure 2.

Before calling service

-
Any sounds you hear when
the ice maker dumps ice into
the bucket are part of normal
operation.
- If you don't dispense ice for a
long period of time, the ice may
form clumps in the ice bucket.
If ice clumps form, remove the
remaining ice and empty the
bucket.
10_ setting up
-
When ice does not come out, check for ice stuck
in the chute and remove it.
- When Ice Off blinks on the display panel,
cAuTION
- When the door is open, the Ice and water
dispenser do not work.
- If you close the door hard, it may cause water
spilling over the ice maker.
-
To prevent dropping the ice bucket, use both
hands when removing it.
-
To prevent injury, be sure to clean up any ice or
water that may have dropped on the floor.
- Do not let the children hang on the ice dispenser
or on the bucket. They may get hurt.
- Be sure not to put your hand or any object into the
ice chute. It may cause personal injury or damage
mechanical parts.
Removing residual matter inside the water
supply line after installing filter.
1. Turn ON the main water supply.
2. Press the Water button and push the Dispenser
Lever.
3. Flush 1 gallons of water through the filter before
use. (Flush approximately 6 minutes.) This will
clean the water supply system and remove air
from the lines.
4. Additional flushing may be required in some
households.
5. Open the refrigerator door and make sure there
are no water leaks coming from the water filter.
Figure 1
Figure 2
A newly installed water filter cartridge may
cause water to briefly spurt from the water
dispenser. This is due to air getting into the
line. It should pose no problem to operation.
Ice chute
reinsert the bucket and/or make sure it's
installed properly.