Kathrein UFO 331/TP Manual Del Usuario página 18

Select the desired level using the "+" and "-" buttons. The following settings are available:
DiSEqC -A or -B off
TM
Ver-Low-1
Hor-Low-1
Ver-High-1
Hor-High-1
Ver-Low-2
Hor-Low-2
Ver-High-2
Hor-High-2
Note: When the DiSEqC
If no matrix is used, the DiSEqC
The DiSEqC controller applies to both sockets and is effective for both A and B concurrently.
TM
1.3 Selecting input frequency
The input frequency in the active channel unit is selected using the "<" and ">" buttons. The input frequency can be set continuously
from 950 MHz to 2150 MHz in 1 MHz steps using the "+" and "-" buttons.
A 1236
27.500 MS/s
Outp. S21
8 MHz
The setting can also be made on a digit-by-digit basis:
• Press the "Change setting mode" button
• The fi rst digit fl ashes and can be input directly using the numeric pad on the keyboard
• After the fi rst digit has been input, the second fl ashes, and so on
• To make a correction, press the "Back" button to skip one place to the left
• After the last digit has been set, press the "Change setting mode" button
The current SNR and the automatically detected operating mode, DVB-S or DVB-S2 of the front end are displayed in the input
frequency sub-menu.
Press the "Sub-menu" button
A 1236
27.500 MS/s
Outp. S21
8 MHz
The displays of SNR and DVB operating modes are valid only in regular operation with the front end clicked into place.
Note: For the SNR display, all parameters must be set and the indicator "*" must not be fl ashing.
Trouble-free operation of the systems requires SNR > 12 dB.
The DiSEqC
TM
In connection with a matrix: Vertical low band position 1
In connection with a matrix: Horizontal low band position 1
In connection with a matrix: Vertical high band position 1
In connection with a matrix: Horizontal high band position 1
In connection with a matrix: Vertical low band position 2
In connection with a matrix: Horizontal low band position 2
In connection with a matrix: Vertical high band position 2
In connection with a matrix: Horizontal high band position 2
controller is switched on, a DC voltage of approx. 12 V is present at the input sockets!
TM
TM controller cannot be switched on.
MHz
3/4
306.00
QAM64
Main menu
(starts the mode)
to activate the sub-menu; press the "Sub-menu" button
MHz
3/4
306.00
QAM64
Main menu
controller is switched off
TP A
QPSK 27.500
MHz Outp.
! 8
Main menu (example for digit-by-digit setting)
to end the mode
TP ***
QPSK SNR
MHz Standard
!
4 / 14
1236 MHz
MS/s
S21 306.00
MHz
again to deactivate it.
UFO331TP
--.-dB
DVB-S
"Input frequency" sub-menu (no signal)
TP
3/4 QPSK
MHz
QAM64 !
***