Packing List; Replacing The Saw Chain - Scotts CS34016S El Manual Del Propietario

UNPACKING
This product requires no assembly.

PACKING LIST

- Chain Saw
- Blade Cover
- Instruction Manual
DANGER: Never start the motor before installing the guide
bar, and chain. Without these parts in place, the clutch can
fly off or explode, exposing the user to possible serious injury.
WARNING: To avoid serious personal injury, read and
understand all the safety instructions provided.
DANGER: Before performing any maintenance, make sure
the tool is unplugged from the power supply. Failure to heed
this warning could result in serious personal injury.
CAUTION: Always wear gloves when handling the bar and
chain; these components are sharp and may contain burrs.
WARNING: Never touch or adjust the chain while the motor
is running. The saw chain is very sharp; always wear
protective gloves when performing maintenance to the chain
to avoid possible serious lacerations.
NOTE: When replacing the guide bar and chain, use only
identical replacement parts.

REPLACING THE SAW CHAIN

•
Disconnect chain saw from power supply. Lay the chain
saw on flat surface.
•
Unscrew the nut by turning the chain cover knob
counter-clockwise.
Chain Cover
ASSEMBLY
REPLACING THE GUIDE BAR AND CHAIN
Chain Cover Knob
Model CS34016S
Carefully remove the product and any accessories from the
box. Make sure that all items listed in the packing list are
included.
Inspect the product carefully to make sure no breakage or
damage occurred during shipping. Do not discard the
packaging material until you have carefully inspected and
satisfactorily operated the product.
WARNING: If any parts are damaged or missing do not
operate this product until the parts are replaced. Failure to
heed this warning could result in serious personal injury. Call
1-800-618-7474 for assistance.
•
Remove the chain cover.
•
Remove the bar and chain assembly from the mounting
surface.
•
Remove the old chain from the bar.
•
Lay out the new saw chain in a loop and straighten any
kinks. The cutters should face in the direction of the chain
rotation. If they face backwards, turn the loop over.
6