Specifications - Alpine CDA-9856 Manual De Operación

Indication for iPod Mode
• The iPod is not connected.
- Make sure the iPod is correctly connected (refer to
"Connections").
Make sure the cable is not bent excessively.
• The iPod's battery remains low.
- Refer to the iPod's documentation and charge the battery.
• There are no songs in the iPod.
- Download songs to the iPod and connect to the adapter.
• Communication error
- Turn the ignition key off, and then set to ON again.
- Check the display by reconnecting between the iPod and the
adapter, using the iPod cable.
• Caused by the iPod Software Version not being compatible with
this unit.
- Update the iPod Software Version to be compatible with this
unit.
28
-EN

Specifications

FM TUNER SECTION
Tuning Range
Mono Usable Sensitivity
50 dB Quieting Sensitivity
Alternate Channel Selectivity
Signal-to-Noise Ratio
Stereo Separation
Capture Ratio
AM TUNER SECTION
Tuning Range
Sensitivity (IEC Standard)
CD PLAYER SECTION
Frequency Response
Wow & Flutter (% WRMS)
Total Harmonic Distortion
Dynamic Range
Signal-to-Noise Ratio
Channel Separation
PICKUP
Wave length
Laser power
GENERAL
Power Requirement
Power Output
*Primary amplifier ratings per CEA-2006 Standard
• Power output: measured at 4 Ohms and
• S/N: 80 dBA (reference: 1 W into 4 Ohms)
Maximum Pre-Output Voltage
Bass
Treble
Weight
CHASSIS SIZE
Width
Height
Depth
NOSEPIECE SIZE
Width
Height
Depth
• Due to continuous product improvement, specifications and design
are subject to change without notice.
87.7-107.9 MHz
9.3 dBf (0.8 µV/75 ohms)
13.5 dBf (1.3 µV/75 ohms)
80 dB
65 dB
35 dB
2.0 dB
530-1,710 kHz
22.5 µV/27 dB
5 - 20,000 Hz (±1 dB)
Below measurable limits
0.008% (at 1 kHz)
95 dB (at 1 kHz)
105 dB
85 dB (at 1 kHz)
795 nm
CLASS I
14.4 V DC
(11-16 V allowable)
18 W RMS × 4*
1% THD+N
2 V/10 k ohms
+20/-14 dB at 100 Hz
±14 dB at 10 kHz
1.6 kg (3 lbs. 8 oz)
178 mm (7")
50 mm (2")
162 mm (6-3/8")
170 mm (6-11/16")
46 mm (1-13/16")
24 mm (15/16")