Publicidad
IS THERE A PROBLEM ?
PROBLEMS
POSSIBLE CAUSES
There is no steam.
The appliance is not
plugged in, or not
switched on.
The water level is too low.
The steam pump has not
been primed.
You are using the appli-
ance for the first time.
The water tank is not fully
in place.
The appliance
It is not plugged in, or not
does not heat.
switched on.
Water leaks.
The water tank is not fully
in place or the stopper is
not closed properly.
The dual voltage is not set
correctly.
Steam rate
Calc Sealing.
decreases.
The steam leaves
You are using water with
stains on the fabric
additives.
or the appliance
The appliance has not
spits.
been cleaned enough after
the descaling operation.
You are using other liquids
than white vinegar to
descale the product.
Appliance steams
The steam trigger is on the
continuously.
lock position.
There is not
The dual voltage is not set
enough power or
correctly.
too much.
28
SOLUTIONS
Check that your appliance is correctly
plugged in and switched on.
Unplug your appliance and refill it.
Press the steam trigger continuously
for a few seconds to begin steaming.
Press the steam trigger continuously
for a few seconds to begin steaming.
Ensure that stopper is closed and that
the water tank snaps when put into
place.
Plug in your appliance and switch on.
Ensure that stopper is closed and that
the water tank snaps when put into
place.
Ensure that the dual voltage selector is
in correct voltage position before oper-
ating. Unplug the appliance and switch
the selector to the correct voltage.
Refer to 'ANTI CALC section in instruc-
tions for use.
Never add any additive in the water
tank.
Read carefully the 'ANTI CALC' section
in instructions for use.
Use only white vinegar during 'ANTI
CALC' procedure.
Unlock the steam trigger.
Ensure that the dual voltage selector is
in correct voltage position before oper-
ating. Unplug the appliance and switch
the selector to the correct voltage.
Publicidad
