Publicidad
Idiomas disponibles
Idiomas disponibles
EN
maintain a correct internal pressure it is best to leave some room for
expansion as the sun heats the air inside the ring. During very hot
weather, you must check to see whether it is necessary to release
some air. This is to avoid any possible damage to the ring.
In no event shall Steinbach, their authorized agents or employees be
liable for damages (such as pin holes) to the inflatable top ring
caused by negligence, ordinary wear and tear, abuse and careless-
nes, or external forces.
Filling oft he pool
Before filling the pool with water ensure that the drain plug inside the
pool is closed and that the drain cap on the outside is screwed on
tightly. Fill the pool with no more than 1inch of water. Check to see
whether the water is level.
IMPORTANT: If the water in the pool flows to one side, the pool is
not completely level. Setting up the pool on unleveled ground will
cause the pool to tilt resulting in the sidewall material to bulge and a
potential collapse of the pool. If the pool is not completely level, you
must drain the pool, level the area and re-fill the pool.
Smooth out the bottom liner wrinkles (from inside the pool) by push-
ing out where the pool floor and pool sides meet. Or (from outside
the pool) reach under the side of the pool, grasp the pool floor and
pull in an outward direction. Image 3,4,5
Now fill the pool with water. The pool liner walls will rise while you
are filling it. Fill the pool with water up to the bottom of the inflated
ring.
Cleaning oft he top ring
To keep the top ring clean and free of stains, wipe the surface with a
damp cloth after each use. Also cover the pool with a pool cover
when not in use. If you have dark stains on the top ring surface, wipe
it with a soft cloth using a solution of mild laundry detergent and wa-
ter. Gently rub the stain and be careful not to let the stain debris fall
into the water. Do not use strong detergents, abrasive material or
brushes.
Winterizing your above ground pool
After usage you can easily empty and store away your pool in a safe
place. We therefore recommend you drain, disassemble and proper-
ly store the pool, when the temperature drops below 0 degrees Cel-
sius.
Remove the skimmer (if applicable) or any accessories attached to
the threaded strainer connector. Be sure all accessories parts are
clean and completely dry before storage.
Remove the ladder (if applicable) and store in a safe place. Be sure
the ladder is completely dry before storage.
Remove the hoses that connect the pump and filter to the pool.
Clean and drain the pump, filter housing and hoses.
The liner must be dried before storage.
Bring pump, filter parts, liner indoors and store in a safe and dry ar-
ea, preferably between 10 degrees Celsius and 40 degrees Celsius.
Steinbach VertriebsgmbH,
Aistingerstrasse 2, 4311 Schwertberg, Österreich
e-mail: service@steinbach.at
www.steinbach.at
Speed-Up Pool | 2015_V1
Page 5 of 30
Publicidad
