Adding/Deleting Rts Sensors; Erase The Memory Of The Motor - SOMFY Sonesse 40 RTS Manual De Instrucciones

7.8 Adding/Deleting RTS sensors

Find an RTS transmitter programmed in the motor.
Press and hold the RTS programmed
transmitter (A) PROG button until the shade jogs:
the motor is in programming mode.
Press briefly the RTS sensor (C) PROG button to
add or delete this sensor: the shade jogs and the
RTS sensor is programmed or deleted from the
motor.

7.9 Erase the memory of the motor.

N.B.: This reset deletes all RTS transmitters,
RTS sensors, end-limits and intermediate
position programmed.
N.B.: Only switch off the current for the motor to
be reset!
N.B.: Before cutting the power, move the shade
to the middle position.
1) Cut the power supply for 2 seconds.
2) Switch the power supply back on for 10 to 15
seconds.
3) Cut the power supply for 2 seconds.
4) Switch the power supply back on: the shade
moves during 5 seconds (If the shade position
is an end limit, the behavior of the shade will be
a jog).
5) Press the RTS transmitter (A) PROG button
until the shade jogs twice: all the RTS transmit-
ters, RTS sensors, end-limits and intermediate
position are cleared.
Copyright © 2009 Somfy SAS. All rights reserved - V0 - 01/2010
PROG.
A
C
PROG.
A
1
2 sec
3
2 sec
5
PROG.
A
X 2
C
PROG.
C
C
PROG.
C
2
10 to 15
sec
4
A B
C
MY
13