HURAKAN HKN-BCF3 Manual Del Usuario página 53

➢ press
indicator lights up and flashes;
➢ press
point) in minutes is displayed;
➢ press
➢ press
displayed, and
➢ press
➢ press
During cooling:
➢ the current probe temperature is displayed;
➢
indicator lights up;
➢ the maximum cooling temperature is set as the r3 cycle parameter;
➢ the maximum cooling time is set as the r5 cycle parameter;
➢ the operating temperature is set as the r7 cycle parameter;
➢ press
- to display the maximum remaining cooling time;
- to display PoS message;
- to display the chamber temperature;
- to exit the mode (or leave for 15 sec for the device exiting the mode independently).
If the temperature measured by the thermal probe reaches the set value before the set
maximum cycle time:
➢ the device switches to the storage mode;
➢ the information on the "End" of the cycle is displayed;
➢ the device provides the sound alarm;
➢ press any button to stop the sound alarm, press again to remove the "End" message.
If the temperature measured by the thermal probe does not reach the set value before
the set maximum cycle time:
➢ the cooling cycle continues;
➢
icon flashes, and
to select the below-zero temperature mode PoS and make sure that
for 15 sec: the set cooling temperature of the probe (cooling limit set
or for 15 sec to adjust the parameter value;
: the temperature of the cooling limit set point (in C°/F°) will be
indicator lights up;
or for 15 sec to adjust the parameter value;
button for 15 sec to activate the cycle.
several times:
indicator lights up;
EN
53