HURAKAN HKN-BCF3 Manual Del Usuario página 54

EN
➢ the device provides the sound alarm;
➢ press
- to stop the sound alarm;
- to display the time elapsed since the set maximum cycle time;
- to display the chamber temperature;
- to display PoS message;
- to exit the mode (or leave for 15 sec for the device exiting the mode independently).
➢ when the temperature of the thermal probe reaches the set value,
- the device switches to the storage mode;
- icon flashes, and
- the information on the "End" of the cycle is displayed;
- the device provides the sound alarm;
- press any button to stop the sound alarm, press again to remove the "End" message.
During storage:
➢ the chamber temperature is displayed;
➢ If the cooling was completed successfully,
the cooling required additional time,
icon flashes;
➢ press
- to display PoS message;
- to exit the mode (or leave for 15 sec for the device exiting the mode independently).
To stop the cycle:
➢ press and hold
10.2.5. Cycle adjustment with the preset temperature in the below-zero temperature
zone
To start the cycle:
➢ make sure that the device is in the stand-by mode;
➢ press
indicator lights up and flashes;
➢ press
point) in minutes is displayed;
➢ press
54
several times:
indicator lights up;
several times:
button for 2 sec.
to select the below-zero temperature mode nEg and make sure that
for 15 sec: the set cooling temperature of the probe (cooling limit set
or for 15 sec to adjust the parameter value;
and
and indicators light up, and
indicators light up; if