Remote Speaker Operation - Midland 200 Manual Del Usuario

Band selector
MIC
Mike
connector

REMOTE SPEAKER OPERATION

A 8 Ohm speaker, rated at 3-10 watts, should be used for this function. Plug the speaker into the
EXT SPKR jack at the rear of the transceiver. When the external speaker is plugged in, the internal
speaker is disconnected. You can now monitor all incoming signals through your remote speaker.
Channels Emission mode
display
RX
TX
RX/TX Up/Down
led buttons
ANT ANT
7
switch
SQUELCH
Squelch
External speaker jack
SPKR SPKR
+ +
- -
Volume/Power switch
ON-OFF/VOLUME
EXT EXT
RED RED
BLK BLK