Electrical Connection; Grounding Instructions - HAMPTON BAY 25-803-68 Guía De Uso Y Cuidado

Safety Information (continued)

ELECTRICAL CONNECTION

A 15-Amp, 120-Volt, 60 Hz circuit with a properly grounded outlet is required. Preferably, the item will be on a
dedicated circuit, as other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow
when the heater is in operation. The unit comes standard with a 6 ft. (1.8 m) long three wire cord, exiting the right side
of the item. Always plug the unit into a wall outlet/receptacle. An extension cord or re-locatable power tap, (outlet/
power strip), should never be used.

GROUNDING INSTRUCTIONS

This heater is for use on 120 volts. The cord has a plug as shown at (A) in Figure 1. An adapter as shown at (C) is available
for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding lug extending from the
adapter must be connected to a permanent ground such as a properly grounded outlet box. The adapter should not be used
if a three-slot grounded receptacle is available.
GROUNDING
PIN
(C)
WARNING: Electrical outlet wiring must comply with local
building codes and other applicable regulations to reduce
the risk of fire, electrical shock and injury to persons.
WARNING: Do not use this fireplace if any part of it has
been under water. Immediately call a qualified service
technician to inspect the fireplace and replace any part of
the electrical system which has been under water.
(A)
ADAPTER
GROUNDING
GROUNDING
MEANS
DANGER
Figure 1
METAL SCREW
COVER OF GROUNDED
OUTLET BOX
(B)
PIN
(D)
4
NOTE: Adapters are NOT
for use in Canada.