ProMinent DULCOTEST BCR Serie Instrucciones De Montaje Y De Servicio página 48

Installation
Electrical Installation
1. Turn the top section of the sensor a
quarter turn anticlockwise and
remove it
2. Loosen the clamping screw on the
M12 connection and feed through
the measuring line from the control
device
Fig. 3: 2-wire connection
3. Strip the cable ends, fit them with
cable end sleeves
(⌀ max = 0.5 mm
cable ends to the 2-wire connec‐
tion: 1 = plus, 2 = minus
4. Bring approx. 5 cm of the meas‐
uring wire into the sensor.
5. Tighten the clamping screw on the
connector
6. Push the top section of the sensor
right into the sensor shaft and
tighten it clockwise up to the stop
48
A0102
2 ) and connect the