Oven Lights; Troubleshooting - Whilpool W11040303C Instrucciones Del Usuario

OVEN RACKS
Cleaning Method:
Steel-wool pad.
■
For racks that have discolored and are harder to slide, a light
■
coating of vegetable oil applied to the rack guides will help
them slide.
OVEN CAVITY AND OVEN DOOR INTERIOR
Do not use oven cleaners.
Food spills should be cleaned after the oven cools. At high
temperatures, foods react with porcelain and staining, etching,
pitting, or faint white spots can result.
Cleaning Method:
Self-Cleaning cycle:
■
See the "Self-Cleaning Cycle" section first.
For optimal door cleaning results, wipe away any deposits with
■
a damp sponge before running cycle.
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid
a service call, refer to the warranty page in these instructions, or visit producthelp.www.whirlpool.com. In Canada, visit
www.whirlpool.ca
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Whirlpool Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
Problem
Nothing will operate
Oven will not operate
Oven temperature
too high or too low
Display shows
messages
Clean cycle did not
work on all spills
Warm air coming
from oven vent
Convection fan runs
during Bake function
Long preheat times
14

TROUBLESHOOTING

Possible Causes and/or Solutions
Household fuse is blown, or a circuit breaker is tripped: Replace the fuse or reset the circuit breaker.
If the problem continues, call an electrician.
Control Lock is on: "Control Lock" will display on the screen. Scroll up to unlock.
Sabbath Mode is set: See the "Sabbath Mode" section.
On double oven models, one oven is self-cleaning: When one oven is self-cleaning, the other
oven cannot be set or turned on.
Oven temperature needs adjustment: See the "Temperature Calibration" section.
Power failure: On some models, reset the clock if needed. See "Preferences" in the "Tools" section.
Error code (display shows letter followed by number): Press the Cancel keypad to clear the display. If it
reapears, call for service. See the "Warranty" section for contact information.
Demo Mode (product is in Demo Mode): See "To Exit Demo Mode" in the "Tools" section.
Several cooking cycles between Clean cycles or spills on oven walls and doors: Run additional Clean
cycles. The affresh Kitchen and Appliance Cleaner can be used for stubborn soils. See the "Accessories"
®
and "Self-Cleaning Cycle" sections for more information.
Warm air coming from the oven vent is normal. During a self-clean cycle, the air stream is increased.
The cooling fan may operate both during an oven's cycle and after the cycle has ended, causing warm
air to exit from the oven vent.
It is normal for the convection fan and element to operate during Bake mode to enhance performance
and heat distribution.
Not all cycles require preheating. See cycle instructions for preheat recommendations. Most cycles
preheat to 350°F (177°C) in 12 to 17 minutes. Higher temperatures will take more time. Removing
unused oven racks prior to preheating can help reduce preheat time.

Oven Lights

The oven light(s) are standard 25-watt appliance bulbs.
Before replacing, make sure the oven is cool and the controls
are turned off.
To Replace:
1. Disconnect power.
2. Open oven door.
3. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
4. Turn bulb counterclockwise to remove from socket.
5. Replace bulb, and then bulb cover, by turning clockwise.
6. Reconnect power.
In Canada:
Whirlpool Brand Home Appliances
Customer eXperience Centre
200 - 6750 Century Ave.
Mississauga, Ontario L5N 0B7