Caster Assembly - Stanley 3Gal El Manual Del Propietario

OPERATING INSTRUCTIONS

CASTER ASSEMBLY

1. Turn tank upside down so that bottom is facing up.
2. Install casters into dolly by inserting the caster stems into the holes provided. Apply pressure and
twisting motion until casters snap into place. Caster will swivel easily when positioning is
correct(Figure 4).
3. Return tank assembly upright position.
DRY PICK-UP DRY PICK-UP
1. The filter must always be in correct position to reduce the risk of leaks and possible damage to vac.
Make sure that the filter is completely covering the filter cage and that the clamp ring is as close to
the lid as possible. Make sure there are no gaps between the filter and the lid. (See illustration). It is
very important to assemble the filter to the cage without allowing any possible leaks or tears. Any
leaks will allow the picked up debris to be blown out of the blowing port and back into the
surrounding environment.
2. When using your vac to pick up very fine dust, it will be necessary to empty the dust tank and clean
or replace the filter at more frequent intervals to maintain peak vac performance.
NOTE:
A dry filter is necessary to pick up dry material. If you use your vac to pick up dust when the filter is wet,
the filter will clog quickly and be very difficult to clean. If the filter gets wet, replace it before continuing to
do dry pickups.
INSTALLING DISPOSABLE FILTER BAG
1. Slide the cardboard collar opening firmly onto the vacuum port deflector until it stops against the
deflector wall.
2. Position the bag so that it is distributed around the inside of the tank.
3. Replace and secure the power head onto the tank.
Reusable filter
Disposable filter bag
Clamp ring
7