Descargar Imprimir esta página

Installation Instructions - Knape & Vogt MU11 Guia De Inicio Rapido

Paniers á usages multiples

Publicidad

Parts Included
A. Wire Basket
B. Slide Bracket Assembly
C. Basket Member Slides (2)
D. Wood Screws (with points) (4)
E. Round Head Machine Screws
(blunt end) (4)
F. Machine Screw Nuts (4)
A
B
D
C
E
F
Tools Required
• Phillips Head Screwdriver
• Drill with 1/16" Bit
for Pilot Holes
• Pencil
• 3/8" Open End Wrench
Product Assemblies
USB11
GUSB11
USB14
GUSB14
2700 Oak Industrial Drive NE
Grand Rapids, MI 49505 USA
800.253.1561 • www.kv.com
©2010 Knape & Vogt. All rights reserved. Knape & Vogt
Multi-Use Basket
with Handle and Accessory Basket

Installation Instructions

Inspect all parts and read all instructions prior to beginning assembly and installation.
NOTE: Basket can be installed with top basket on right hand side or left
hand side. Determine which orientation is best for your installation.
Be sure to install slides as described below with wheels to the rear of the
basket as you wish it to be installed.
Identify right and left basket member slides as shown. Attach to basket
1
(A) using round head machine screws (E). Insert a screw into hole
furthest from wheel and into hole in basket brace. Place nut (F) onto
screw and slightly tighten. Insert second screw (E) into opposite end of
slide (near wheel) in hole that aligns with basket brace and attach nut
(F). Push slide tightly against basket and tighten nuts to hold in place.
Repeat on other side.
Place slide bracket assembly (B) on cabinet fl oor 1/2" to 3/4" from the
2
front of the cabinet. Close doors to make sure unit will not hold cabinet
door open. Fasten in place using wood screws (D) provided.
Optional: To avoid splitting wood you may mark placement of screws
with pencil, remove unit and drill pilot holes for fastening screws.
Slide basket into slide bracket assembly by inserting wheels on basket
3
x (4)
into tracks on slide bracket assembly. The basket should move freely
along the track.
x (4)
1
x (4)
Basket Brace
Round Head
Machine Screw
2
reserves the right to change specifi cations without notice. Made in USA.
®
Nut
Slide
(right drawer
member shown)
3
Angle
basket to fit
into slides
310233-A-1010

Publicidad

loading

Este manual también es adecuado para:

Mu14Usb11-tm-rUsb14-tm-rUsb11tmUsb14tmUsb11 ... Mostrar todo