c.Using the hacksaw, cut off the
adjustment screw flush to the fixing
cover.
d.Remove the adjustment screw, fixing
cover and cartridge cover.
※An additional adjustment screw is
included. If cutting is not succesful, use
the spare adjustment screw and cut
again. The fixing cover has no further
use. Dispose of it properly.
WARNING:
●DO NOT turn the adjustment screw
when cutting.
●No burr should be on the cut
surface of the screw.
●DO NOT loose the screws when
removing the installation plate.
III.Installation: Trim
1. Lining Plate Installation
WARNING:
●Before installing the lining
plate, make sure the water
stop valve is fully open and
conduct a water pressure test
to check if the valve is
installed properly.
●Press the cartridge and
confirm if the water flow at the
end of the circuit is normal. If
the flow is less than normal,
unscrew the water stop valve
and clean the filter net inside.
●Turn the rod on the water
stop valve to an
appropriate position
according to the water
amount required.
INSTALLATION PROCEDURE
Hack saw
Cut out
protrudes
Cartridge cover
Stop
Hot water
Stop valve
Hot water
Stop valve
Open
Flow reduces
Hot water
Flow increases
Stop valve
6
Adjustment screw
Fixing cover
Stop
Cold water
Stop valve
Cold water
Stop valve
Open
Cold water
Stop valve