Mounting Instructions - Whale UF2415B Instrucciones De Uso E Instalación

• WARNING: Fire hazard. Wiring must comply with the applicable electrical standards and include a properly rated fuse or circuit breaker. Improper wiring can cause a
fi re resulting in injury or death. Switch off the power while making connections.
• Suggested wiring information is for guidance only. For full information, please refer to relevant ISO standards and regulations for marine applications.
• Do not screw directly to the hull – MUST be mounted on a bulkhead or an additional board.
• A Whale® strainer is fi tted on the inlet of each pump to prevent dirt/debris entering the pump. They must not be removed.
Contact Whale Support Tel: +44 (0)28 9127 0531 or email info@whalepumps.com for specifi c advice on your installation.
6. PARTS
QTY: 1 Pre-assembled Frame
QTY: 2 Freshwater Pressure Pump
QTY: 2 Whale® Strainer
QTY: 1 2 ltr Accumulator Tank
QTY: 2 External Pressure Switch
QTY: 1 Pre-assembled Plumbing
Inlet Strainers
2 Ltr Accumulator Tank
Figure 1a Product Components View 1
7. INSTRUCTIONS FOR INSTALLATION
The High Capacity Freshwater Kit is designed for freshwater use in recreational vessels, typical installation is shown in Figure 2.
Overall dimensions of the High Capacity Freshwater Kit are shown in Figure 3. The High Capacity Freshwater Kit uses ¾" (19mm) barb connections on the inlet and
outlet (Figure 5a, 5b and 5c). The outlet should be connected into the freshwater system at a central location.

Mounting Instructions

Step 1 Locate in a dry position with adequate ventilation and no more than 3m (9ft) above the water tank. In normal use, ensure the kit cannot be submerged in water.
Step 2 Ensure the kit is mounted free of obstacles and is accessible for maintenance.
Step 3 Use stainless steel screws and washers to secure the kit to a solid surface. Four screws and washers can be used through the centre of the feet (see Fig. 4a), or
8 screws and washers as shown in Fig 4b.
DO NOT screw directly to the hull – MUST be mounted to a bulkhead or additional board.
Primary pump electrical connections
Secondary pump electrical connections
3/4" (19mm) reinforced hose
Figure 2 Typical Installation in Marine System (illustration for guidance purposes only)
External pressure switch,
controlling secondary pump
3/4" (19mm) barb outlet
External pressure switch,
controlling primary pump
2
Figure 1b Product Components View 2
Primary pump
Secondary pump
3/4" (19mm) barb inlet