Caple CR700 Manual Del Usuario página 17

(within 5 seconds). Leds flashing 6 times
indicate the procedure is completed.
WARNING! This operation deletes
permanently the preset codes.
Emergency button:
In the event that the radio control does not
work, use the emergency button to switch
the appliance off. After any necessary repairs
have been performed, reset the emergency
button.
WARNIING
The battery should be replaced every year
to guarantee the optimal range of the
transmitter.
To replace the exhausted battery, take
the plastic lid off, remove the battery and
replace it with a new one, observing the
correct battery polarities.
Used batteries should be discarded in
special collection bins.
The below product:
RC001 Radiio Controll
complies with the specifications set out in
the R&TTE Directive 99/5/EC.
WARNING
Any adjustments or modifications which
have not been expressly approved by the
holder of the legal conformity certificate
may invalidate the user's rights relating to
the operation of the device.
The products are endowed with an electronic
device which allows the automatic switching
off after 4 hours working from the last
operation.
Rev. 0 26/08/14
17
TIMING
As a result of the new EU65 "Energy label" and
EU66 " Ecodesign" regulations issued by the
European Commission, which came into force
as from January 1st, 2015 , our products have
been adapted to comply with these new
requirements.
All of the models complying with the energy
label requirements, are equipped with new
electronics including a timer device for
extraction speeds control, when the air
capacity exceeds 650m³/h.
Internal motor models, with maximum air
capacity higher than 650m³/h, are
equipped with a timer device that
automatically switches the extraction speed
from 4th to 3rd speed, after 5 minutes
operation.
External motor models are equipped with
remote motors that , as for internal motor
versions, include a timer device that switches
down the extraction speed when it exceeds
650 mᵌ/h. (See External Motors Instructions ).
Remote motors, whose air capacity exceeds
650m³/h at both 4th and 3rd speed, will have
the following by default timer control
functions: The extraction speed is
automatically switched from 4th to 2nd
speed, after 6 minutes operation.
If the appliance is working at 3rd speed, it
is automatically switched to 2nd speed, after
7 minutes operation. Operation speeds can
also be changed during operation.
The energy consumption of the appliance in
standby mode is lower than 0.5W.