Technical Data; General Safety Advice For Electrical Power Tools; Workplace Safety - Parkside X3.6-LI A Instrucciones De Utilización Y De Seguridad

technical Data

Q
X3.6-LI A cordless screwdriver:
Rated voltage: 3.6 V
Rechargeable battery
(integrated): LITHIUM
Rechargeable battery
capacity: 1350 mAh
No-load speed: n
Torque: max. 4 Nm
Tool holder: 6.35 mm (
X3.6-LI A-1 mains adapter:
InPUt:
Rated voltage: 230 - 240 V ~ 50 / 60 Hz
Rated power: 5,5 W
OUtPUt:
Rated voltage: 6,2 V
Rated power: 400 mA
Charging time: Approx. 3 hrs.
Protection class: II /
noise / vibration data:
Values determined in accordance with EN 60745
The sound pressure level (A-weighted) of the device
is typically 55 dB (A). Uncertainty K = 3 dB.
The sound level while working can exceed 80 dB (A).
Total vibration (vector sum of three directions) is
calculated in accordance with EN 60745:
Screwing: Vibration emission value
a = 2.101 m / s
h,D
uncertainty K = 1.5 m / s
WArnInG! The vibration level given in these
instructions has been measured in accordance with
a standardised measurement procedure specified
in EN 60745 and can be used to compare devices.
Different uses of the device give rise to different
vibration levels and in many cases they may exceed
the values given in these instructions. It is easy to
underestimate the vibration load if the electrical power
tool is used regularly in particular circumstances.
note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
Introduction / General safety advice for electrical power tools
200 min
-1
0
/ ")
1
4
,
2
2
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
General safety advice
for electrical power tools
read all the safety advice
WArnInG!
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
KEEP ALL THE SAFETY ADVICE AND INSTRUC-
TIONS IN A SAFE PLACE FOR FUTURE REFER-
ENCE! THE TERM "ELECTRICAL TOOL" USED
IN THE SAFETY ADVICE REFERS TO ELECTRICAL
TOOLS POWERED BY MAINS ELECTRICITY (BY
MEANS OF A MAINS LEAD) AND ELECTRICAL
TOOLS POWERED BY RECHARGEABLE BATTER-
IES (WITHOUT A MAINS LEAD).

1. Workplace safety

a) Keep your working area clean and
well lit. Untidy or poorly lit working areas
can lead to accidents.
Do not work with the device
b)
in potentially explosive envi-
ronments in which there
are inflammable liquids, gases or
dusts. Electrical power tools create sparks,
which can ignite dusts or fumes.
c) Keep children and other peo-
ple away while you are op-
erating the electrical tool.
Distractions can cause you to lose control of
the device.
GB/MT 31