General Warnings - Kramp GOPART FGP455239GP Manual Del Usuario

GENERAL WARNINGS

READ and UNDERSTAND this manual completely before using Push Spreader.
Operator must read and understand all safety and warning information, operating
instructions, maintenance and storage instructions before operating this equip-
ment. Failure to properly operate and maintain the push spreader could result in
UK
serious injury to the operator or bystanders.
Operation Warnings
• Do not at any time carry passengers on the spreader.
• Do not allow children to play on, stand upon or climb in the spreader.
• Always inspect the spreader before using to assure it is in good working condi-
tion.
• Replace or repair damaged or worn parts immediately.
• Always check and tighten hardware and assembled parts before operation.
• Do not exceed equipment maximum load capacity of 125lb.
• Avoid large holes and ditches when transporting loads.
• Be careful when operating on steep grades (hill) the spreader may tip over.
• Do not push close to, ditches and public highways.
• Do not use spreader on windy days when spreading grass seed or herbicides.
• Always use caution when loading and unloading spreader.
• Never tow the spreader with a motorized vehicle.
Crush and Cut Hazards
• Always keep hands and feet clear from moving parts while operating the equip-
ment.
• Always clear and keep work area clean when operating.
• Always wear safety gear, eye protection, gloves and work boots when operating
the spreader.
WARNING
The warnings, cautions, and instructions outlined in this instruction manual can-
not cover all possible conditions or situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product and must be supplied by the operator.
Assembly Is Required
This product requires assembly before use. See "Assembly" section for instructions.
Because of the weight and/or size of the push spreader, it is recommended that
another adult be present to assist with the assembly. INSPECT ALL COMPONENTS closely
upon receipt to make sure no components are missing or damaged.
2