GreenWorks G40 Traducción De Las Instrucciones Originales página 3

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SV HR HU RO BG EL AR TR HE LT LV ET
ASSEMBLING THE SPRAY WAND (See Figure 2.)
„ Installing Wand to Pressure Washer Gun Insert the
male baynet end (15) of the wand into the female
bayonet outlet (16) firmly.While pushing in the wand
firmly,turn clockwise until tabs lock into place to
ensure a leak-free connection.
ASSEMBLING THE GUN HOLDER (See Figure 3.)
„ Push the gun holder as shown until it is locked into
the slots.
ASSEMBLING THE WATER INLET CONNECTOR
(See Figure 4.)
„ Align the connector with the water intake.
„ Rotate the connector clockwise to ensure it is tight.
ASSEMBLING THE PEDESTAL (See Figure 5.)
„ Line up the pedestal and screws with the holes.
„ Insert the screw and turn clockwise with a
screwdriver until the screw is tight.
OPERATION
Applications
This pressure washer can be used for the purposes
listed below:
„ Removing dirt and mould from decks, cement
patios, and walls.
„ Cleaning cars, boats, motorcycles, outdoor furniture
and barbeques.
CONNECTING HIGH PRESSURE HOSE (See Figure
6.)
Fiting
„ Push the connector (17) of the high pressure hose
into the mount (18) on the trigger handle until it
engages.
Removing
„ Actuate the spring button (19) and pull the high
pressure hose out of the mount.
CONNECTING THE WATER SUPPLY TO PRESSURE
WASHER (See Figure 7.)
The water supply must come from a water main.
NEVER use hot water or water from ponds, lakes, etc.
For ease of use, a self-coiling hose (not provided) is
recommended.
NOTE: When using the self-coiling hose, be sure that
the hose does not become crimped during use as this
may cause damage to the pump.
English (Original instructions)
When connecting the appliance to the water sup-
ply mains (not public drinking water supply mains),
please observe the local regulations of local boards
or local water supplier.
To ensure that there is no transfer of contaminant
into the water supply, the appliance must not be con-
nected directly to the public drinking water supply
mains.
If the appliance is connected to portable water
mains, backflow prevention devices should be incor-
porated in or fixed to the water supply system. The
installation should be accepted by local boards or
water supplier and should be conducted by profes-
sional technical personnel. The backflow prevention
devices should be appropriate to fluid categories and
comply with the requirement to avoid back siphon-
age according to EN 60335-2-79:2009.
Always switch off the mains disconnecting switch
when leaving the machine unattended
Inadequate extension cords can be dangerous. If an
extension cord is used, it shall be suitable for outdoor
use, and the connection has to be kept dry and off
the ground. It is recommended that this is accom-
plished by means of a cord reel which keeps the
socket at least 60mm above the ground.
Before connecting the garden hose to the pressure
washer:
„ Run w ater through the hose for 120 seconds to
clean any debris from the hose.
„ Inspect the filter in the water intake.
„ If the filter is damaged, do not use the machine until
the filter has been replaced.
NOTE: There must be a minimum of 3 metres of
unrestricted hose between the pressure washer intake
and the garden tap.
„ With the garden tap turned completely off, attach
the end of the garden hose to the threaded tap
connector.
USING THE GUN (See Figure 8.)
For greater control and safety, keep both hands on the
gun at all times.
„ Squeeze the trigger (20) to operate the pressure
3
CAUTION
WARNING
WARNING