Storing The Pressure Washer - GreenWorks G40 Traducción De Las Instrucciones Originales

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SV HR HU RO BG EL AR TR HE LT LV ET
POWER SUPPLY CORD REPLACEMENT
If replacement of the power supply cord is necessary,
this must be done by an authorized service centre in
order to avoid a safety hazard.
NOZZLE MAINTENANCE (See Figure 13.)
Excessive pump pressure (a pulsing action felt while
squeezing the trigger) may be the result of a clogged
or dirty nozzle.
„ Unplug the pressure washer.
„ Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
„ Remove the nozzle from the lance.
NOTE: Never point the spray lance at your face.
„ Using a straightened paper clip or nozzle cleaning
tool, free any foreign materials clogging or restricting
the nozzle.
„ Using a garden hose, clear/flush debris out of
nozzle.
„ Reconnect the nozzle to the lance.
„ Turn on the water supply.

STORING THE PRESSURE WASHER

Store in a dry, covered, frost-free area where the weath-
er can't damage it. Always empty water from gun, hose
and pump.
NOTE: The use of a pump protector is recommended
to prevent cold weather damage during storage over
the winter months.
DISPOSAL
This marking indicates that this product should not
be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment
or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse
of material resources. To return your used device,
please use the return and collection systems or contact
the retailer where the product was purchased. They can
take this product for environmental safe recycling.
English (Original instructions)
5