Craftsman 247.88999 Manual Del Operador página 9

5. Finish securing chute control assembly to chute support bracket
with wing nut and hex screw removed earlier. See Figure 4.
6. Check that all cables are properly routed through the cable guide
on the lower handle. See Figure 5.
7. The extension cord for the electric starter is fastened with a cable
tie to the rear of the auger housing for shipping purposes. Cut the
cable tie and remove it before operating the unit.
set-UP
shear Pins
Holes are located in the plastic dash panel for convenient shear pin
storage. See Figure 6. Refer to the Operation section for more informa-
tion regarding shear pin replacement.
ASSEMBLY
Figure 4
9
Figure 5
Figure 6