Safety Instructions And Warnings; Identification Of The Product - PLYMOVENT SFE-25 Instrucciones Para El Uso

1 PREFACE
ENGLISH
Using this manual
This manual is intended to be used as a work of
reference for professional, well trained and authorised
users to be able to safely install, use, maintain and
repair the product mentioned on the cover of this
document.
The figures referred to in the text, can be found in the
back of this manual.
Pictograms and symbols
The following pictograms and symbols are used on the
product and in this manual.
WARNING
.
Denotes risk of electric shock.
WARNING!
.
Wait approximately 10 seconds after
switching off the motor before dismounting
the ionizer and collector. These electrostatic
components need approx. 10 seconds to
discharge.
Suggestions and recommendations to
.
simplify carrying out tasks and actions.
WARNING
.
Procedures, if not carried out with the
necessary caution may damage the product
or cause personal injury.
WARNING
.
j
Fire hazard! Never use the product for
extracting and/or filtering inflammable,
glowing or burning particles or solids or
liquids. Never use the product for extracting
and/or filtering of aggressive fumes (such as
hydrochloric acid) or sharp particles.
Service and technical support
For information about specific adjustments,
maintenance or repair jobs which are not dealt with in
this manual, please contact the supplier of the product.
He will always be willing to help you. Make sure you
have the following specifications at hand:
- product name
- serial number
These data can be found on the identification plate.
2 IDENTIFICATION OF THE
PRODUCT
The identification plate (fig. 1) contains the following
data:
0508080010/SFE-HFE/010111/G
A serial number
B product name
C power
D supply voltage and frequency
3 SAFETY INSTRUCTIONS AND
WARNINGS
General
The manufacturer does not accept any liability for
damage to the product or personal injury caused by
non-observance of the safety instructions in this
manual, or by negligence during installation, use,
maintenance and repair of the product mentioned on
the cover of this document and any corresponding
accessories.
Specific working conditions or used accessories may
require additional safety instructions. Immediately
contact your supplier if you detect a potential danger
when using the product.
The user of the product is always fully
responsible for observing the local safety
instructions and regulations. Observe all
applicable safety instructions and regulations.
User manual
• Everyone working on or with the product, must be
familiar with the contents of this manual and must
strictly observe the instructions therein. The
management should instruct the personnel in
accordance with the manual and observe all
instructions and directions given.
• Never change the order of the steps to perform.
• Always keep the manual with the product.
Pictograms and instructions on the product
• The pictograms, warnings and instructions
attached to the product are part of the safety
features. They must not be covered or removed and
must be present and legible during the entire life of
the product.
• Immediately replace or repair damaged or illegible
pictograms, warnings and instructions.
Users
• The use of this product is exclusively reserved to
authorised, trained and qualified users. Temporary
personnel and trainees can only use the product
under supervision and responsibility of skilled
engineers.
EN - 10