Tool Specifications - Bostitch HP118K Manual De Operación Y De Mantenimiento

MAINTAINING THE TOOL
When working on air tools note the warnings in this manual and use extra care when
evaluating problem tools.

TOOL SPECIFICATIONS

All screws and nuts are metric.
MODEL
HP118K
FASTENER SPECIFICATIONS:
MODEL
HP118K
TOOL AIR FITTING:
This tool uses a free-flow connector plug, 1/4" N.P.T. The minimum inside diameter should be .200" (5mm).
The fitting must be capable of discharging tool air pressure when disconnected from the air supply.
OPERATING PRESSURE:
70 to 100 p.s.i. (4.9 to 7.1 kg/cm
performance. DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
AIR CONSUMPTION:
Model HP118K requires 1.86 cubic feet per minute (.053 cubic meters) of free air to operate at the rate of 100
fasteners per minute, at 80 p.s.i. (5.6kg/cm2). Take the actual rate at which the tool will be run to determine the
amount of air required. For instance, if your fastener usage averages 50 fasteners per minute, you need 50%
of the tool's c.f.m. of free air which is required for running at 100 fasteners per minute.
LENGTH
9.06" (230.1mm)
HEADLESS
PIN SERIES
PT-23XX
2 ). Select the operating pressure within this range for best fastener
HEIGHT
7.81" (198.4mm) 1.60" (40.6mm)
GAUGE FASTENER RANGE
23 3/8"- 1-3/16" (9-30mm)
-4-
WIDTH WEIGHT
2.17lb. (.984kg.)
MAGAZINE
CAPACITY
200 PINS