Using The Belt Hook - Bostitch HP118K Manual De Operación Y De Mantenimiento

USING THE BELT HOOK

Always disconnect tool from air supply when making adjustments or servicing.
The operator must not hold the secondary trigger pulled except during fastening operation
as serious injury could result if the trigger accidentally contacts someone or something,
causing the tool to cycle.
Never inadvertently pull or grasp the secondary trigger when moving about, changing work
location, when holstering or hanging tool, or when preparing work surface for fastening
operation.
OPERATION AND ORIENTATION:
The belt hook can be adjusted to two orientations; open or closed. The open orientation allows the user to
hang the tool from a belt (or equivalent) whereas the closed position allows the user to place the tool back
inside the case. The following depicts these two orientations:
OPEN
In order to adjust the tool to either of these orientations, simply push down on the belt hook, rotate clockwise
or counter-clockwise and release as shown in FIG 1.
1. PUSH DOWN ON BELT HOOK
2. ROTATE
-8-
CLOSED
3. RELEASE
Fig.1