Parameter Setting Block Via Password; Table 15: Error Status Messages On Main Page; Table 16: Status Bar Indications; Figure 12: Menu Parameter Display - DAB ACTIVE DRIVER PLUS M/T 1.0 Instrucciones De Instalación Y Mantenimiento

BP1
BP2
NC
F1
F3
F4
P1
P2
P3
Com. icon with
number
Com. icon with E
Ei
Vi
EY
EE
No power supply Warning due to power supply voltage failure
The other menu pages vary according to the associated functions, and are described below according to the type of
specification or setting. After entering any one of the menus, the lower section of the page always shows a summary
of the main operating parameters (operating status or possible fault status, applied frequency and pressure).
This enables a constant overview of the main machine parameters.
Identifier
GO
SB
FAULT
The following can be shown on parameter display pages: numerical values and unit of measurement of current item,
values of other parameters related to setting of current item, graphic bar, lists; see Figure 12.
To preserve the screen, the page displayed disappears 10 min after the last key was pressed and the screensaver is
shown. The screensaver switches off all the display pixels and an algorithm lights them in random order.

3.4 Parameter setting block via Password

The inverter is equipped with a password protection system. If a password is set, the inverter parameters will be
accessible and visible, but it will not be possible to change them, except the parameters SP, P1, P2, P3, RP, FP, LA,
CT, MS.
In turn, the parameters SP, P1, P2, P3 are limited by SX (SX is subordinate to the password). The password
management system is located in the menu "technical assistance" and is managed by means of parameter PW, see
paragrap 6.6.20 .
Blockage due to reading error on the internal pressure sensor
Blockage due to reading error on the remote pressure sensor
Pump not connected
Float function status/alarm
System disable function status/alarm
Low pressure signal function status/alarm
Operating status with auxiliary 1 pressure
Operating status with auxiliary 2 pressure
Operating status with auxiliary 3 pressure
Operating status in multi inverter communication with specified address
Error status in communication of multi inverter system
Blockage due to i-th internal error
Blockage due to i-th internal voltage out of tolerance
Block for cyclicality abnormal detected on the system
Writing and rereading on EEPROM of the factory settings

Table 15: Error status messages on main page

Figure 12: Menu parameter display

Status bar indications at the bottom of each page
Electric pump ON. In case of no flow, the indicator blinks.
Electric pump OFF
Presence of error that prevents control of the electric pump

Table 16: Status bar indications

ENGLISH
Description
71