Cleaning the filter
To clean the coarse filter and the fine filter, use a cleaning brush. Reassemble
the filter parts as shown in the figures in the last page and reinsert the entire
assembly in the dishwasher, positioning in its seat and pressing downward.
WARNING:
ters could be contorted and the performance of dishwasher could be debased.
CARING FOR THE DISHWASHER
The control panel can be cleaned by using a lightly dampened cloth and dry
thoroughly. The exterior use a good appliance polish wax. Never use sharp
objects, scouring pads or harsh cleaners on any part of the dishwasher.
Cleaning the door
WARNING:
door lock and electrical components. Abrasive agent or some paper towel should not be
used because of the risk of scratching or leaving spots on the stainless steel surface.
Protect against freezing
Please take frost protection measures on dishwasher in winter. Each
time after washing cycles, please operate as follows:
1.
Cut off electrical power to the dishwasher.
2.
Turn off the water supply and disconnect the water inlet pipe from the water valve.
3.
Drain water from the inlet pipe and water valve. (Use a pan to catch the water)
4.
Reconnect the water inlet pipe to the water valve.
5.
Remove the filter at the bottom of the tub and use a sponge to use up water in sump.
NOTE:
If your dishwasher cannot work because of the ice, please contact professional service persons.
Cleaning the spray arms
The spray arms can be easily removed
for periodic cleaning of the nozzles, to
prevent possible clogging. Wash them
under running water and carefully replace
them in their seats, checking that their
rotary movement is in no way impeded.
Grasp the middle of the spray
19
When cleaning the filters, don't knock on them. Otherwise, the fil-
To clean the edge around the door, you
should use only a soft warm, damp cloth.
To avoid penetration of water into the
door lock and electrical components, do
not use a spray cleaner of any kind.
Never use a spray cleaner to clean the door panel as it may damage the