Resistance Test; Diode Test; Circuit Continuity Test - koban KPA 02 Manual Del Usuario

Resistance test

Warning
Electric shock hazard.
When measuring circuit impedance, determine that the power supply is
disconnected and the capacitor in the circuit is completely discharged.
• Insert black probe to the COM jack and insert red probe to the INPUT jack.
• Place measuring range switch in
• The meter is in the measurement state.
• Connect the probe to the both ends of resistor or circuit to be tested for
measurement.
• LCD will show readings.
Note:
1. When the input end is open, LCD shows "0L"out-of-range condition.
2. When the resistance to be tested > 1MΩ, the meter reading will stabilize
after a few seconds, which is normal for high resistance readings

Diode test

• Insert black probe to the COM jack and insert red probe to the INPUT jack.
• Place measuring switch in position
• Press the FUNC key to switch to
• Connect the red probe to diode anode and connect the black probe to
diode cathode to make test.
• LCD will show readings.
Note:
1. What the meter shows is an approximation of diode forward voltage drop.
2. If the probe has reverse connection or the probe is open, the LCD will
show "0L"

Circuit continuity test

Warning
Electric shock hazard.
When measuring circuit continuity, determine that the power supply is
disconnected and the capacitor in the circuit is completely discharged.
www.grupotemper.com
Digital clamp meter
position.
.
measuring state.
Instructions manual |
KPA 02
33