Default Settings - Toshiba FlashAir W-04 Manual De Instrucciones

800TOSH(8674) IDD charges apply outside UAE
Email : 121@toshiba-tgfz.ae SKYPE : Toshiba.TGFZ
2. Technical Information about the Product
The Product can be used with devices of compatible
card capacity and card type. SDHC memory card can
be used with SDXC compatible devices and SDHC
compatible devices. SDXC memory card can be used
only with SDXC compatible devices.
Before using the Product, read the manual carefully
and entirely for the device in which you intend to use
the Product (hereafter your device). Procedures may
vary depending on whether your device supports
FlashAir™. If your device supports FlashAir™, use the
Product according to the procedures in your device's
manual. If your device does not support FlashAir™,
use the Product according to the procedures in this
manual and your device's manual.
This manual explains how to install the necessary
application software (hereafter App) for the Product
use. After the App is installed in your Wireless LAN
device (such as smartphone and PC), follow the
guidance of App or refer to the help of App.
The Product is formatted, which is compatible with
SD Association specification, you can use the Product
as it is. However, if the manual of your device requires
formatting the Product before using, format the
Product using the format function of your device.
Formatting the Product causes all the data stored in
MN9025-D0.indb 5
the Product to be lost. Back up your data on some
other storage media before formatting the Product.
After you format the Product using your device, i)
turn off your device, ii) take out the Product from your
device, iii) reinsert the Product into your device, iv) turn
on your device and v) perform the procedure of the
initial settings following App's guidance or refer to help
information in the App.
Precautions about Wireless LAN
Wireless LAN communication sends and receives data
between devices, such as personal computers, and
access points by means of radio transmissions rather
than wires. The radio transmissions enable a wireless
LAN connection even if there are obstructions.
Users should take appropriate security measures to
prevent third parties from hacking or stealing data
transmitted wirelessly. Before using the Product, install
App and perform the initial settings following App's
guidance or refer to help information in the App.
Note that there is a possibility that communications
over a wireless LAN may be hacked by using some
heretofore unheard of way.

Default settings

• SSID flashair_xxxxxxxxxxxx
(x represents the MAC address of the Product)
• Security WPA2™ password (security key): 12345678
• Encryption and authentication WPA2 AES (access
point mode)
5
2017/09/08 13:14:16