First Operation - SLV NAULTILUS LED 304 Instrucciones De Montaje

INSTALLATION MANUAL for OUTDOOR LIGHT
NAULTILUS LED 304
ONLY FOR THE ELECTRICIAN!
The installation may only be carried out by an approved
electrician, who is familiar with valid directives and
regulations!
In case of disregarding this manual the warranty will be void!
Pay also absolute attention the NOTES ON SAFETY on the
backside!
1. INSTALL AS DIRECTED
This product serves exclusively lighting purposes and may:
only be connected to a voltage of 230V ~50Hz.
only be operated when firmly mounted.
not be exposed to strong mechanical loads or to strong
contamination.
only be installed and operated after a condition inspection if the
product is dirty or has been moistened through storage.
not be modified or converted.
2. UNPACKING
Consignment:
Fastening materials
Carefully take the product out of the packaging removing any
transport safeguards.
Before disposal of the packaging material make sure that all
components of the product are removed.
Inspect the product for loose parts inside the housing. When there are
loose parts inside the housing and these are not explicitly described the
product may not be installed or operated.
Parts that may be touched are maybe voltage-carrying. Danger of
electric shock!
3. INSTALLATION
Switch off the mains or respectively the connection lead before doing
.
any works
There exists mortal danger from an electric shock.
Use only accessory parts, which are supplied with the product or are
described as accessories!
Otherwise the product or the whole installation may not be secure.
Danger for life or danger of fire may exist!
Installation place
230801/02: The product is solely suited for installation on the wall,
ceiling and floor.
230811/12: The product is suited for installation on the ground.
Choose a place where the installation is not a danger (e.g. stumbling,
knocking).
Use the supplied fastening material only when it is suited for the
installation background. If this is not the case use only fastening material
suiting the installation background.
When using fastening material that is not suitable there may be danger
from falling objects.
Separate Installation Steps
Prepare the power supply lead according to valid rules for outdoor
installations.
230801/02: Fasten the fixture to the installation place using properly
dimensioned fastening materials.
Electrical Connection
Use an outdoor connection box (e.g. SLV 228730) to connect the
fitting to the power supply. The cable on the fitting may not be laid out
underground.
230811/12: The earth spike must be anchored in the ground, so that the
product cannot fall down. The ground may not be permanently wet.
Electrical Connection
Connect the plug with a suitable outdoor socket (e.g. SLV 227000).
Ensure that the light fixture holds securely!
The product is now ready for operation.
4.

FIRST OPERATION

On the first operation check if the product functions properly!
In case of a malfunction you may NOT touch the product or operate it
further. Disconnect the product from the power supply by an external
switch or by the fuse.
If touched or further operated there is danger from electric shock,
burning, or fire.
A malfunction exists when:
visible damages appear.
the product does not work properly (e.g. flickering).
smoke, steam or crackling sounds appear.
smell of burning is recognisable.
an overheating is recognisable (e.g. by discolouration of adjacent
surfaces).
Operate the product only after maintenance and examination by an
approved electrician!
Notice for the electrician:
It is your responsibility to hand out the user manual on the reverse
side to the end user.