Trouble Shooting; Before You Call For Service - Danby Designer DWC110BLSRH Manual Del Usario

Before You Call For Service

Problem
No Power
Cabinet Temperature
too High
"Clicking" Noise
Condensation on the
cabinet and/or door
If none of the above rectify the situation please contact our customer care department
at 1-800-26-

Trouble Shooting

Possible Cause What to do
A fuse in your home may
be blown or the circuit
breaker tripped.
Power surge.
Plug not fully inserted into
wall outlet
Temperature setting
Door not shut properly
or opened excessively
Recently added a large
quantity of warm bottles
to the cabinet
Normal sound
High humidity conditions
in the home
Door not shut properly
or opened excessively
(1-800-263-2629)
11
Replace fuse or reset circuit breaker.
Unplug the wine cooler, wait a few
seconds and then plug it back in.
Make sure the 3-prong plug on the
wine cooler is fully inserted into outlet.
Verify the temperature control setting.
Adjust if neccessary.
Ensure that the door is fully closed
and that the gasket is sealing
against the cabinet. Open the door
only as needed and for short periods
of time.
Limit the quantity of warm bottles
being introduced to the cabinet at the
same time. Attempt to phase in the
load introduction if possible.
No user intervention is required as
this sound is normal during the opera-
tion of the appliance. This audible
'clicking' noise may be heard as the
wine cooler ends or begins a cooling
cycle.
The condensation will subside once
humidity conditions return to normal.
Ensure that the door is fully closed
and that the gasket is sealing
against the cabinet. Open the door
only as needed and for short periods
of time.