Maintenance; Emptying The Dust Cup; Cleaning The Filters - Shark Rocket AH452W Manual Del Usuario

MAINTENANCE

To keep your vacuum's suction power optimal, follow these instructions.
IMPORTANT: Allow ALL filters to dry completely before replacing in the vacuum.
Make sure unit is off and cord is unplugged.
STEP 1

EMPTYING THE DUST CUP

1 Detach the removable Dust Cup from the Motorized Floor Nozzle by pressing the Dust Cup Release Foot Pedal located on the left side near the Nozzle.
2 Holding the Dust Cup by the handle, lift it up to remove it from the Motorized Floor Nozzle.
3 Hold the Dust Cup over a garbage bag or can, then press the Empty button on the side of the Dust Cup. The bottom lid will open, allowing the debris to
fall out.
4
Clean the dust screen inside the Dust Cup as required.
Pre-Motor Filters
Filter Access Latch

CLEANING THE FILTERS

Pre-Motor Filters
Access the Pre-Motor Filters by pressing the FILTER ACCESS latch on the
top of the Dust Cup. Remove and rinse the foam and felt filters every
month. Let air-dry COMPLETELY before replacing in the vacuum. Hand
wash only. Tap loose dirt off filters between washes as needed. Insert the
felt filter first, and then place the foam filter on top of it.
7
STEP 2
Post-Motor Filter
Access the Post-Motor Filter on the top of the Motorized Floor Nozzle.
Remove and rinse once a year. Let air-dry completely before replacing.
Hand wash only.
RECOMMENDED FILTER CLEANING SCHEDULE:
Pre-Motor Filter Kit (Foam & Felt):
Post-Motor Filter:
www.sharkrocketpowerhead.com
STEP 3
Post-Motor Filter
Every month
XFFH400
Every year
XEXFH400