Assembly; To Assemble The Guide Bar And Saw Chain - Zenoah GZ3500T Manual De Usuario

• Drive link width (mm/inches)
• Number of drive links.
Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
WARNING: Always wear protective gloves
when you assemble the saw chain.
To assemble the guide bar and saw
chain
1. Move the front hand guard towards the front handle
to disengage the chain brake.
12
Cutting equipment designed to reduce kickback
The only way to avoid kickback is to make sure that the
kickback zone of the bar never touches anything. By
using cutting equipment with "built-in" kickback reduction
and keeping the chain sharp and wellmaintained you
can reduce the effects of kickback.
Guide bar
The smaller the tip radius the lower the chance of
kickback.
Saw chain
A chain is made up of a number of links, which are
available in standard and low-kickback versions.
WARNING: No saw chain design eliminates
the danger of kickback.

Assembly

2. Remove the bar nuts and the clutch cover. Remove
the transportation guard.
3. Put the guide bar over the bar bolts. Steer the guide
bar to its most rear position. Lift the saw chain above
the drive sprocket and engage it in the groove on the
guide bar. Start on the top edge of the guide bar.
4. Make sure that the edges of the cutting links are
turned forward on the top edge of the guide bar.
308 - 004 - 27.09.2017