Publicidad
CUB 20/90 & MIDI 20/110D, 20/140 & MAJOR 20/140X, 20/160X, 30/140
Filter Condition
Change filter canister when needle enters
and stays in the red zone during operation.
Use only Belle Group approved by-pass
type canister.
By-Pass
Out
Hose couplings must be cleaned before connecting
(failure to do so may cause damage to seals, and
invalidate the warranty)
Part No. 01890
Manufactured by Belle Group, Sheen,Nr.Buxton, Derbyshire, GB. Tel:- +44 (0)1298 84606
1
THE RED DOT
INDICATES THE
CORRECT OIL LEVEL
1
01900 ..............Decal ..................................Autocollant ...............................Rótulo ......................................... Decalque ..................................... 20/90 ............................. 1
1
01892 ..............Decal ..................................Autocollant ...............................Rótulo ......................................... Decalque ..................................... 20/110D ........................ 1
1
01886 ..............Decal ..................................Autocollant ...............................Rótulo ......................................... Decalque ..................................... 20/140 ........................... 1
1
01890 ..............Decal ..................................Autocollant ...............................Rótulo ......................................... Decalque ..................................... 20/140X ........................ 1
1
02348 ..............Decal ..................................Autocollant ...............................Rótulo ......................................... Decalque ..................................... 20/160X ........................ 1
1
01889 ..............Decal ..................................Autocollant ...............................Rótulo ......................................... Decalque ..................................... 30/140 ........................... 1
2
01424 ..............Decal - Hydraulic Oil ............Autocollant - Huile Hydraulique .Rótulo - Aceite Hidraulico ........... Decalque - Óleo Hidráulico ................................................ 1
3
01619 ..............Decal - Safety ......................Autocollant - Sécurité ................Rótulo - Seguridad ..................... Decalque - Segurança ....................................................... 1
4
01621 ..............Decal - Noise ......................Autocollant - Bruits ....................Rótulo - Ruidos ........................... Decalque - Ruído ............................................................... 1
5
01888 ..............Decal - Hydraulic Filter ........Autocollant - Filtre Hydraulique .Rótulo - Filtro Hidráulico ............. Decalque - Filtro Hidráulico ................................................ 1
6
01965 ..............Decal ..................................Autocollant ...............................Rótulo ......................................... Decalque ............................................................................ 1
7
01964 ..............Decal ..................................Autocollant ...............................Rótulo ......................................... Decalque ............................................................................ 1
ISO VG T32 spec. for ambient Temperatures below 32°C
Flow
ISO VG T46 spec. for ambient Temperatures above 32°C
ENGINE WILL NOT RUN IF LEVEL IN TANKS IS TOO LOW
In
4
HYDRAULIC FILTER
ASSEMBLY INSTRUCTIONS. LUBRICATE GASKET
SPIN FILTER ONTO THREADED ADAPTER UNTIL
GASKET CONTACT. TIGHTEN ADDITIONAL 3/4 TO 1
TURN. RUN SYSTEM AND CHECK FOR LEAKS.
7
2
Hydraulic Oil
01
DO NOT OVERTIGHTEN
Belle Group Head Office
Sheen, Nr. Buxton, Derbyshire, SK17 OEU, GB
Tel: +44 (0)1298 84606 Fax: +44 (0)1298 84621
196
Manufactured By:- Belle Group
Sheen, Nr. Buxton, Derbyshire, SK17 OEU, GB. Tel: +44 (0)1298 84606
THIS LEVER IS PRESET
AT THE FACTORY
DO NOT ADJUST
6
MAR '09
3
Publicidad
