Inspection And Testing; Installation; Framing - Jacuzzi SOAKER Serie Instrucciones Para La Instalación Y El Funcionamiento

Inspection and Testing

Visual Inspection
Remove the bathtub from the shipping carton. Be careful not to scratch the surface of the bathtub on exposed
1
staples. Remove the staples or fold them into the carton. Retain the carton until satisfactory inspection of the
product has been made. Do not lift the bathtub by the plumbing at any time; handle by the shell only.
Inspect the shell and bathtub components. Should inspection reveal any damage or defect in the finish or visible
2
damage to any components, do not install the bathtub. Damage or defect to the finish claimed after the bathtub
is installed is excluded from the warranty. Jacuzzi Luxury Bath's responsibility for shipping damage ceases upon
delivery of the products in good order to the carrier.
Refer any claims for damage to the carrier. For definitions of warranty coverage and limitations, refer to the
3
published warranty information packed with the product or in the back of this manual.

Installation

A technical specifications manual has been included with your bathtub. The Technical Specifications Manual will
contain pertinent information regarding your Jacuzzi Luxury Bath product. Locate the Technical Specifications Manual
at this time.

Framing

Frame out the space where the bathtub is to be located. The
following should be taken into consideration when preparing
the area:
•
Dimensions provided on rough-in diagrams are nominal.
Measure your actual unit upon receipt and build
according to the actual dimensions.
•
The floor structure beneath the bathtub must be able to
support the total weight of the bathtub, water and bather.
Please refer to the Technical Specifications Manual
(column marked 'Total Weight/ Floor Loading').
•
The unit must be supported from the bottom of the
bathtub and not from the bathtub rim. For drop-in
installations, take into account the thickness of the
surround material and finishing material (marble, tile,
etc.).
•
Ensure the rim will rest on a level surface.
•
Per code, access must be provided to the chromatherapy
control panel box (if equipped). Service access
locations are shown in the rough-in diagrams contained
in the Technical Specifications Manual (Figure 1).
It is the responsibility of the installer, building
contractor, or owner to provide access for service.
Jacuzzi is not responsible for any costs relating to
obtaining access for repair. The owner shall bear such
costs and, if appropriate, must seek recovery from the
installer.
Page 6
OVERFLOW
Figure 1 - Common Access Location
www.jacuzzi.com
Soaker™ Bath Series
CHROMATHERAPY
LIGHT LOCATIONS
F
Installation and Operation