Adjust The Front-Back Position Of The Display Unit (Optional); Attach The Sheet Cap (Only Necessary When The Front-Back Position Of The Display Unit Is In The Forward Position); Mounting The Gps Antenna Inside The Vehicle - Alpine HALO 9 INE-F904D Manual De Instalación

Adjust the front-back position of the Display
unit (Optional)
Depending on the vehicle, it may be necessary to adjust the front-
back position of the Display unit when mounting it.
If front-back position adjustment is necessary, set the slider to the
back position before mounting the display unit to the vehicle.
[Default setting: forward position]
WARNING
MAGNETIC SCREWDRIVER REQUIRED TO
CAREFULLY REMOVE SCREWS.
1
Remove 4 flush head screws from the Top and Bottom of
the main unit.
Flush head screw
Flush head screw
2
Push the slider to the back position (To return the slider
to the forward position, pull it forward).
Slider
4
-EN
3
Attach the Sheet cap (Only necessary when
the front-back position of the Display unit is in
the forward position)
Only attach the Sheet cap when the front-back position of the Display
unit is in the forward position.
Main unit

Mounting the GPS Antenna inside the vehicle

1
2
3
• Do not mount the GPS Antenna inside the centre console.
- Mount the GPS Antenna on a flat plane of the dash board or rear
- Make sure the GPS Antenna is not covered (obstructed) by any
Tightly fix the slider using the 4 screws that were
removed in Step 1.
Flush head screw
Flush head screw
Sheet cap
Clean the mounting location.
Put on the GPS Antenna mounting plate.
Mount the GPS Antenna.
Antenna mounting plate
This unit
tray.
metallic surface or object.
GPS Antenna