Extending The Device's Lifetime; In Case Of Problem - Atlantic 2012 Serie Manual De Uso

e
Perform this operation once per year to increase your device's lifetime and optimise its operation:
Switch the device off:
Wait at least one hour (cool-down time);
Be sure to remove towels from the device, protect your wall and yourself (wearing recommended
glasses);
Use the key provided in the wall support kit and follow the steps.
Store the key in a clean and dry place (at ambient temperature).
tProblems Encountered
The device does not heat - Ensure that the main circuit breakers are closed or that the overload
The device heats all the
time
xTending The deviCe
i
n CaSe oF ProBLem
cut-out has not cut off the supply to the advice.
- Check the air temperature in the room : if it is too high, the heating
light C does not come on: the device does not heat.
- Switch your heating oFF and then on again with the mode selection
wheel a :
• If the indicator light C flashes constantly (continuous flashing): the
measuring sensor is defective. Contact the manufacturer's local After-
Sales service in order to replace it.
- Ensure that the device is not locked in the Frost-Free position.
- Check that the device is not locked onto a low temperature. If this is
the case, unlock the device and increase the temperature using the
temperature setting wheel d (see page 21).
- Check that the device is not located in a draft or that the temperature
setting has not been changed.
- There may be a fluctuation in the electricity supply. If you experience
a problem (thermostat locked, ...), cut off the electricity supply to the
towel-dryer (via the fuse or circuit breaker) for approx. 10 minutes and
the switch it on again.
- If you encounter the same phenomenon frequently, have your power
supply checked by your local utility.
- Check that the device is not locked onto too high a temperature. If
this is the case, unlock the device and reduce the temperature using
the temperature setting wheel d (see page 21).
'
S LiFeTime
Checks to be made
24