Variable Installation Possibilities: Overlying Installation; Variable Installation Possibilities: Flush Installation - KÜPPERBUSCH KMI9850.0 Manual De Instrucciones

7.4 Variable installation possibilities:
Overlying installation
Dimensions in mm
4
R5
min.50
1
Minimum distance to adjacent walls
Opening dimensions
Cutout dimensions
Outer dimensions of the hob
Important:
There is a risk of breakage if the hob is canted or subjec-
ted to stress during installation!
84 x 455
Instructions for assembly
4
898
2 860+1
2 4
1 min.50
7.5 Variable installation possibilities:
Flush installation
3
R7
2
min.50
1
Glue the sealing tape onto the corner of the supporting
edge of the worktop so that no silicone adhesive can be
pressed under the hob.
Place the hob into the worktop cut-out without any adhesi-
ve and align it. Use shims if necessary
Fill the gap between the hob and the worktop with heat-re-
sistant silicone adhesive.
Important
Silicone adhesive must not get under the support surface.
If this occurs it will not be possible to remove the hob again
at a later stage. No liability will be assumed in the case of
failure to observe these instructions.
3
84 x 455
902+1 3
860+1
2
min.50
1
GB
3
39