Velleman VM119 Manual Del Usuario página 5

CONFIGURING K8058 / VM118R AS 'PULSE'
ATTENTION: Each channel of the VM118R (or K8058) used to control the VM119 must be set in "PULSE" mode. Keys
set to operate in toggle mode will not be accepted by the VM119.
Each relay can be individually configured to behave as a toggle (ON/OFF) or as a pulse contact.
Hold 'shift' until the LED on the remote lights to enter the 'set-up'-mode then press '1' to enter output setup mode :
Press a button (1..8) to change the function of the corresponding output:
•
LED flashes once: pulse mode,
•
LED flashes twice: toggle mode.
Next, press 'shift' several times until the LED turns off to leave setup mode (*).
NOTE : Use an external antenna when reception is not sufficient or when the module is located near a metal object.
Solder some flexible wire (length of min. 30cm) to the ANT point on the PCB and pull the wire out of the housing. This
wire will serve as an antenna.
TO LEARN A REMOTE (BUTTON):
At power-on, LD1 will flash a # of times, hereby indicating that the unit is operational. Next, LD4 will turn-on.
At first power-on, the unit will respond to channel(1)/button(1) of the K8058/VM118R transmitter. Make sure the transmitter
buttons are configured as 'pulse'.
Configuration
5