Bostitch CAP2041ST-OL Manual De Operación Y De Mantenimiento página 11

If any of the above conditions cannot be met, or if operation of the compressor
repeatedly causes interruption of the power, it may be necessary to operate it from
a 20 amp circuit. It is not necessary to change the cord set.
COMPATIBILITY
Air tools and accessories that are run off the compressor must be compatible
with petroleum-based products. If you suspect that a material is not compatible
with petroleum products, an air line filter for removal of moisture and oil vapor in
compressed air is required.
NOTE: Always use an air line filter to remove moisture and oil vapor when spraying
paint.
OPERATION
KNOW YOUR AIR COMPRESSOR
READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING
YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the
location of various controls and adjustments. Save this manual for future reference.
DESCRIPTION OF OPERATION (FIG. 4)
FIG. 4
H
G
F
M
N
P
J
Q
R
D
K E L
Become familiar with these controls before operating the unit.
Auto (I)/Off (O) Switch (D): Place this switch in the Auto (I) position to provide
automatic power to the pressure switch and Off (O) to remove power at the end
of each use.
Pressure Switch (E): The pressure switch automatically starts the motor when the
air tank pressure drops below the factory set "cut-in" pressure. It stops the motor
when the air tank pressure reaches the factory set "cut-out" pressure.
Safety Valve (F): If the pressure switch does not shut off the air compressor at
its "cut-out" pressure setting, the safety valve will protect against high pressure by
"popping out" at its factory set pressure (slightly higher than the pressure switch
"cut-out" setting).
Tank Pressure Gauge (G): The tank pressure gauge indicates the reserve air
pressure in the tank.
11 - ENG