Publicidad
A
B
C
Mixed Water Supply
2. Adjust the Handle Assembly
NOTE: Valve Operation. Water will flow from a single shower
accessory when the control knob detent lines up with any of the
markings on the escutcheon. Water will flow from two accessories at
the same time when the control knob detent is midway between the
markings.
Ensure the valve stem adapter is lightly placed over the spline
adapter.
Place the handle assembly over the valve stem adapter.
Turn on the water supply to the transfer valve.
Rotate the handle assembly until water begins to flow through
the shower accessory.
Determine the shower accessory that will correspond to the
Accessory "A" setting at the 12 o'clock position on the escutcheon
for the 3-way installation or 4 o'clock for the 2-way installation.
Turn the handle to the detent setting that corresponds with
Accessory "A." The handle should be in the 12 o'clock position
for the 3-way installation or 4 o'clock for the 2-way installation.
Repeat for each detent; verify flow to each accessory.
Turn off the water supply to the transfer valve.
Remove the handle assembly and set aside.
To adjust for handle alignment:
Kohler Co.
Spline Adapter
Valve Stem Adapter
Handle Assembly
A + C
A
B
B + A
2-Way
5
A
A + B
C
B
B + C
3-Way
1204800-2-A
Publicidad
