AUDIOropa xepton-NX TR Instrucciones De Servicio página 14

3.6 Audio output high / low
Apart from the volume control, it is possible to adjust the basic audio output level. A
higher audio output will raise the maximum volume – this might be required in noisy
surroundings.
On the powered-up device, press and hold the MODE-button for 3 seconds. The sym-
bol »GRP« in the display will blink.
Press the MODE button three times. The »UH« symbol is shown in the display. By using
the » « and » « buttons, select UH (high output) or UL (normal output). After the se-
 
lection, wait for 3 seconds to set the selected output level.
Please note:
Selecting »UH« can cause white noise and should only be used in loud environments.
We recommend the default setting »UL«.
3.7 Transmission power
The setting of the transmitting power affects the radio signal range.
On the powered-up device, press and hold the MODE-button for 3 seconds. The sym-
bol »GRP« in the display will blink.
Press the MODE button four times. By using the » « and » « buttons, select »P1« for
 
the lowest transmission power and »P7« for the highest. After the selection, wait for 3
seconds to set the selected transmission power level.
Please contact your authorized AUDIOropa dealer if more than 6 units within signal
range are to be authorised to transmit.
English 14