Taking Out Of Service; Maintenance; Cleaning; Replacing A Module - TDK relyon plasma piezobrush PZ3 Manual De Instruccion

8

Taking out of service

•
Press the Start/Stop button again to stop plasma generation.
•
Disconnect the power supply once work is completed.
9

Maintenance

9.1

Cleaning

•
Clean the device only on the outside.
•
Make sure that the device is disconnected from the power supply.
•
Clean the device only with a cloth moistened with water. Do not use solvents to clean
the device!
•
Do not clean the piezo element.
9.2

Replacing a module

The modules can be subject to wear depending on the application and should be
exchanged for consistent treatment results. Proceed as described in section 7.1.
You can obtain replacement modules directly from relyon plasma GmbH. To optimize our
modules, we evaluate returned modules. Please contact us and send us back your
defective or replaced modules for analysis.
Attention – Damage to device!
Never touch the piezo element at the front end of the device with sharp objects. This
component can be damaged by improper handling.
22 BA-PZ3_ML / F0354401