Installation: Power Supply And Poe (Power Over Ethernet) Connection; Power Supply - Velleman CAMIP18 Guía Rápida

•
Use the spirit level to check the surface is horizontal or not, and adjust the tightness of the three M6
Nylok screws.
•
When you make sure the surface is horizontal, use the M4 screw supplied with the bracket package
to fix the camera and the bracket tightly.
4. Connect the cables to your router (and to a power adapter if you are not using the Power over
Ethernet feature). For detailed connection, please refer to section 6 below.
5. Put back the upper part of the bracket, and finish the installation.
•
Place the upper part of the bracket back to the bottom part of the bracket, and fasten the bracket
with the M6 Nylok screw loosened in STEP 1.
•
Then use the cap supplied with the package to cover it and finish the installation.
6. Installation: Power Supply and PoE (Power over Ethernet)
Connection

Power Supply

For your camera to work properly, you need to connect the camera cables as follows:
1. Connect the network cable [1] to your network.
2. Plug the camera's power cable [7] in a suitable power adapter (12 Vdc 1 A, for example PSSE1210,
not incl.) and connect it to a power socket.
V. 01 – 14/02/2014
CAMIP18
1
8P8C network cable
2
alarm in (yellow)
3 GND (brown)
4 RESET (red)
5 GND (black)
6 alarm out (pink)
7
power cable
4 ©Velleman nv